User Profile

embefors 61

Bio Statement

The Way to Replace a Toilet

You are able to turn on a fan if the Air Conditioner breaks, bar-b-que when the cooker shoots matches or hire the neighborhood child if the machine stops, but something that you definitely can't do without is... a functioning bathroom.

Call a plumber the simplest way to replace a bathroom is to become from the Yellow Pages and cover him a $ 1000. This will get the one outside for the garbage man along with you a water closet, since it known to, installed. (possibly )

Although that a bargain that is sensible, you can do exactly the job yourself. You do not need to be should you follow my simple to comprehend directions to carry out this fix Even though I am a plumber. Ready?

To begin with, let us visit Lowes your local Home Depot or supplies to be bought by anything provider around your house. Plumbing fixtures are much like a vehicle. There is the base version or the fully loaded version that is $35,000. We are going to remain with the base version.

Buy a bathroom, which includes tank and all the commode boxed, but priced. All new bathrooms come equipped with the tank assembled's areas.

Buy a wax ring, the kind with all the rubber flange attached, a toilet water supply line and not sink water . I suggest the water lines across the plastic, chrome or copper water lines. As you're at it might as well get a new toilet seat.

Eliminating the broken bathroom. Listed below are the basic actions to eliminating the cracked fixture. 
1. Turn off the water at the stop valve. 
2. Flush the toilet allowing it to drain as much water from this trap When the water is shut off. It does not hurt to try flushing it. 
3. Lift the top. Based on the total amount of water in the tank use a sponge or a wet vac to eliminate it. 
4. Unscrew the water distribution line in the tank's base. Have a rag useful because water will still leak out. 
5. Are two bolts. Unscrew these 2 bolts and lift the tank. Eliminate into the garbage.
6. There are two, one on both sides of the bathroom, closet bolts that hold the bathroom. Remove, Whether there are caps on the bolts or pop them open. Employing a crescent wrench unscrew the nuts. When reinstalling the bolts, but anyway, alternate side to side once unscrewing, this is going to be more significant. 
7. Slowly rock the bathroom base back and forth to break the seal After washers and the nuts are eliminated from the bolts. Lift up bathroom until the cupboard bolts clear. At this point you have the bathroom. 
8. There'll be also a pit, that's the sewer line, in the ground and a closet flange. Put a rag loosely to maintain anything from developing a clog and falling right into it. Do not lose the rag. 
9. There'll be residual of it or a wax ring. Scrape all of off the wax and wash clean. It has to be clean or risk the possibility of a flow.
10. Set the bathroom and unwrap. Set the wax side from the bathroom bottom in which bathroom and the sewage pipe will meet. Press into position. 
11. Lifting the bathroom, and being careful to not hit on the ground or anything else that can undermine the wax ring, set the bathroom. Insuring the rubber flange goes down to the tube push on the bathroom down on the ground. 
12. Reinstall the nut and washers on finger tighten and the cupboard bolts. Sit on the best flushing toilet with a slight movement and also your own weight by enlarging the wax ring, to fasten it. 
13. The nuts tighten . Every single is turned on by alternate sides. The proper is turned on by six. . .six turns on the leftside. . .and so on till the bathroom is fastened. Because you can break the bathroom destroying its foundation, Don't over tighten. 
14. Remove in the box and fasten it from within the tank. 
15. Replace the toilet water supply line. Turn on the ground and permit the tank to fill with water, watching for any signs of a flow, which 99 percent of the time will come from the 2 bolts used to fasten the tank into the toilet foundation or where the distribution line connects into the bathroom or the shutoff. 
16. Flush toilet viewing for any escapes. 
17. Install the toilet chair.
18. It is not a terrible concept, but not mandatory to conduct a bead of caulking around the bottom of the ground and the bathroom.

There you go. Finished. You paid @$200 for components along with a brand new bathroom vs. $1000 for a plumber, a trendy savings of $800.